Configuring HanDreamnet (HDN) Security Switch Connectors

You can connect Stellar Cyber to a HanDreamnet (HDN) switch and block an IP address from within Stellar Cyber, while you are threat hunting.

Connector Overview: HanDreamnet

Capabilities

Collect: No
Respond: Yes
Native Alerts Mapped: No
Runs on: DP or Sensor
Interval: 5 minutes

Collected Data

N/A

Domain

https://<Device IP Address>

where <Device IP Address> is a variable from the configuration of this connector

Response Actions

Action	Required Fields
Block IP	`srcip` or `dstip`

Third Party Native Alert Integration Details

N/A

Required Credentials

Device IP Address and Token

Let us know if you find the above overview useful.

Adding an HDN Connector

To add a new HDN connector:

Obtain HanDreamnet credentials
Add the connector in Stellar Cyber
Test the connector

Obtaining HanDreamnet Credentials

To configure this connector you must first obtain the following information:

The Device IP address of the switch
An API Token

Adding the Connector in Stellar Cyber

To add a HanDreamnet connector in Stellar Cyber:

Log in to Stellar Cyber.
Click System | Integration | Connectors. The Connector Overview appears.
Click Create. The General tab of the Add Connector screen appears. The information on this tab cannot be changed after you add the connector.

The asterisk (*) indicates a required field.
Choose Security Switch from the Category drop-down.
Choose HanDreamnet Security Switch from the Type drop-down.
For this connector, the supported Function is Respond, which is enabled already.
Enter a Name.

This field does not accept multibyte characters.
Choose a Tenant Name. The Interflow records created by this connector include this tenant name.
Choose the device on which to run the connector.
- Certain connectors can be run on either a Sensor or a Data Processor. The available devices are displayed in the Run On menu. If you want to associate your collector with a sensor, you must have configured that sensor prior to configuring the connector or you will not be able to select it during initial configuration. If you select Data Processor, you will need to associate the connector with a Data Analyzer profile as a separate step. That step is not required for a sensor, which is configured with only one possible profile.
- If the device you're connecting to is on premises, we recommend you run on the local sensor. If you're connecting to a cloud service, we recommend you run on the DP.
Click Next. The Configuration tab appears.

The asterisk (*) indicates a required field.
Enter the Device IP Address to access the switch.
Enter the Token you obtained in the previous section.
Click Next. The final confirmation tab appears.
Click Submit.

The new connector is immediately active.

Testing the Connector

When you add (or edit) a connector, we recommend that you run a test to validate the connectivity parameters you entered. (The test validates only the authentication / connectivity; it does not validate data flow).

Click System | Integrations | Connectors. The Connector Overview appears.
Locate the connector that you added, or modified, or that you want to test.
Click Test at the right side of that row. The test runs immediately.

Note that you may run only one test at a time.

Stellar Cyber conducts a basic connectivity test for the connector and reports a success or failure result. A successful test indicates that you entered all of the connector information correctly.

To aid troubleshooting your connector, the dialog remains open until you explicitly close it by using the X button. If the test fails, you can select the button from the same row to review and correct issues.

The connector status is updated every five (5) minutes. A successful test clears the connector status, but if issues persist, the status reverts to failed after a minute.

Repeat the test as needed.

Display sample messages...