Configuring AWS Firewall Connectors

You can connect Stellar Cyber to firewalls so that you can quickly and easily implement firewall rules on those firewalls from within Stellar Cyber, while you are threat hunting. You can configure firewall actions or manually trigger a firewall action from the event display. For either action you must already have your firewall connected.

Connector Overview: AWS Firewall

Capabilities

Collect: No
Respond: Yes
Native Alerts Mapped: No
Runs on: DP
Interval: N/A

Collected Data

N/A

Domain

N/A

Response Actions

Action	Required Fields
Block IP	`srcip` or `dstip`

Third Party Native Alert Integration Details

N/A

Required Credentials

Access Key ID, Secret Key, ACL ID, and Region Name

Let us know if you find the above overview useful.

Adding an AWS Firewall Connector

To add an AWS firewall connector:

Add the connector in Stellar Cyber
Test the connector

Adding the Connector in Stellar Cyber

To add a new AWS firewall connector in Stellar Cyber:

Log in to Stellar Cyber.
Click System | Integration | Connectors. The Connector Overview appears.
Click Create. The General tab of the Add Connector screen appears. The information on this tab cannot be changed after you add the connector.

The asterisk (*) indicates a required field.
Choose Firewall from the Category drop-down.
Choose AWS from the Type drop-down.
For this connector, the supported Function is Respond, which is enabled already.
Enter a Name.

This field does not accept multibyte characters.
Choose a Tenant Name. The Interflow records created by this connector include this tenant name.
Choose the device on which to run the connector.
Click Next. The Configuration tab appears.

The asterisk (*) indicates a required field.
Enter the Access Key ID to log in to the firewall.
Enter the Secret Key to log in to the firewall.
Enter the ACL ID.
Enter the Region Name.
Click Next. The final confirmation tab appears.
Click Submit.

The new firewall connector is immediately active.

Testing the Connector

When you add (or edit) a connector, we recommend that you run a test to validate the connectivity parameters you entered. (The test validates only the authentication / connectivity; it does not validate data flow).

For connectors running on a sensor, Stellar Cyber recommends that you allow 30-60 seconds for new or modified configuration details to be propagated to the sensor before performing a test.

Click System | Integrations | Connectors. The Connector Overview appears.
Locate the connector that you added, or modified, or that you want to test.
Click Test at the right side of that row. The test runs immediately.

Note that you may run only one test at a time.

Stellar Cyber conducts a basic connectivity test for the connector and reports a success or failure result. A successful test indicates that you entered all of the connector information correctly.

To aid troubleshooting your connector, the dialog remains open until you explicitly close it by using the X button. If the test fails, you can select the button from the same row to review and correct issues.

The connector status is updated every five (5) minutes. A successful test clears the connector status, but if issues persist, the status reverts to failed after a minute.

Repeat the test as needed.

Display sample messages...